Haxorware Forums - data receive LED blinking on ecp2100

ouch.........

i tried to using differ f/ware
previously(old) running on haxorware11rev39

since the epc has bmc3349 then i tried to run 250hack_dump_telnet.bin
(SB5101.firmware.upgrade.tutorial.by.FERCSA)

after upload completed reboot

ouch... only data receive led blinking
(LED LAN and Power: on; ok)

ping to the modem still valid
C:\ping 192.168.100

Pinging 192.168.100.1 with 32 bytes of data:

Reply from 192.168.100.1: bytes=32 time=1ms TTL=63
Reply from 192.168.100.1: bytes=32 time=1ms TTL=63
Reply from 192.168.100.1: bytes=32 time=1ms TTL=63
Reply from 192.168.100.1: bytes=32 time=1ms TTL=63

Ping statistics for 192.168.100.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 1ms, Maximum = 1ms, Average = 1ms

using WebAccess to the web interface seem right but its say error like "the page contain error message"
(Web interface login: Infinite password: SetValue)

any help?.... to debrick using pxe boot/ install

ouch......................

the infinite webpage does not work on any browser other than IE (internet explorer)

(24-02-2012, 01:28 PM)drewmerc Wrote: [ -> ]the infinite webpage does not work on any browser other than IE (internet explorer)

thank you for info

yes... the IE is the go to view the infinite-ware
i trying to 250_config without success

telnet to 192.168.100.1 also no success

actualy I wanna get it back to haxorware11rev39
anyclue on these?

close the webpage stop pinging the modem and then try accessing telnet manually

also try using Amchobit i always thought it was better than ntl250

(24-02-2012, 08:27 PM)drewmerc Wrote: [ -> ]close the webpage stop pinging the modem and then try accessing telnet manually

also try using Amchobit i always thought it was better than ntl250

still no go to connect to the telnet however the i tried to reduce the process by connect to coax but still no go

hopeless....its half brick need jtag, i do not have one...

some one can lend it to me?....

just buy a cheap ttl cable http://www.ebay.com/sch/i.html?_trkparms...p=15&_sc=1 and fix it the old serial way

(25-02-2012, 10:03 AM)drewmerc Wrote: [ -> ]just buy a cheap ttl cable http://www.ebay.com/sch/i.html?_trkparms...p=15&_sc=1 and fix it the old serial way

thank you very much your assistance...... GBU

[quote='hao' pid='8592' dateline='1330177963']
[quote='drewmerc' pid='8589' dateline='1330160608']

just buy a cheap ttl cable http://www.ebay.com/sch/i.html?_trkparms...p=15&_sc=1 and fix it the old serial way

well, just its come back with reborn-alife modem.... using haxor of course... bravo drewmerc with his tip jtag.. its so easy...... yep elcheapo jtag 5buck