Haxorware Forums

Hi everyone,

Today i tried to flash Haxorware to my SB5101i with Blackcat USB. But i can't do this successfully. Blackcat detecting the modem but flashing functions not seeing on Blackcat software. I use Build 326. It won't load script. I receiving "Cannot process if statement..." error.

Here is my console log.

Code:
LibUsbDotNet version: 2.2.8.104

BlackcatUSB Script Engine build: 202

Welcome to BlackcatUSB interfacing software, build: 326

Running on: Microsoft Windows XP Home Edition (32 bit)

Initializing EJTAG engine

Device connected in JTAG mode: 7,05

JTAG: IR length set to 5

JTAG engine setup successfully

Detected CPU ID: 0x334917F IMP CODE: 0x800904

Manufacturer ID: 0xBF Part ID: 0x3349

EJTAG Version support: 2.0

Target device supports DMA mode

Checking for a device specific script to automatically load

Loading script: SB5101_JTAG.bcs

Error loading: Can not process a If statement inside a If statement

No scripts to run

Disconnected from BlackcatUSB

on the first tab change the script to the 2100 one, it's for the webby but it should work just as well on a 5100 (i guess there just a typo in the current 5101 script)

Loading script: DPC2100_JTAG.bcs
Setting device parameter (Intel Flash delay) to 0x32
Setting device parameter (AMD Flash delay) to 0xAF
Setting device parameter (Memory Read Delay) to 0x32
Error in script DPC2100_JTAG.bcs on line 19
Reason: error parsing command: if not (Memory(CFGFLASH).Exist)

I tried to load 2100 script but it doesn't work too. Sorry i don't understand your words in brackets Smile

By the way i didn't subscribed with that modem. I didn't plug coax ever. This is a new one. Could this be the reason?

i still think it's a script issue so i'll send you here http://blackcatusb.net/

Finally i succeeded. I installed a clean Windows release with drivers and .NET Framework only. I tried to flash on it and it's wok! Smile

good for you

deathroll

drewmerc

deathroll

drewmerc

deathroll

drewmerc