US and DS levels? Do NOT tick IGNORE any T-1/to T-3 timeouts
us.. 2
ds..586750000 / 330750000
any other settings i need to make sure I need to disable or enable...
I had t1, t2, t3 ticked but now Unticked
Anything else
(21-03-2013, 08:17 PM)naynesh Wrote: [ -> ]us.. 2
ds..586750000 / 330750000
any other settings i need to make sure I need to disable or enable...
I had t1, t2, t3 ticked but now Unticked
Anything else
Ok, that doesnt look right. I believe you listed the frequencies instead of the power levels for upstream and downstream. They should end in dbmv or just DB. Check again towards the top right of Haxorware in the blue area..
here's the info requested:
Downstream
Frequency -- 586 MHz
Status -- Locked
Annex -- EuroDOCSIS
Modulation -- QAM256
Symbol Rate -- 6952000 sym/sec
Receive Power -- -5.3 dBmV
Signal to Noise ratio -- 38.3 dB
Upstream
Frequency -- 22 MHz
Channel ID -- 2
Status -- Ready
Mode -- TDMA
Symbol Rate -- 2560000 sym/sec
Transmit Power -- 42.0 dBmV
why do i get the feel that your running with an stb config
stb configs have a habit of randomly dropping connection also speed is shit slow
run a speedtest
10mg download and 1mg Upload...
Seems to be ok now as I made changes as above...
Anything I need to worry about or be prepared for???
Old Skool TDMA..any1 see that?
DOCSIS 1.0/1.1