Haxorware Forums

How can I flash the firmware to Cisco 2100?

Can please give me a link?

I also have the SB5100i if thats easier?

Sorry Im new.

2100 OR 2100R2.

2100 has 3348 chip r2 has 3349 chip. Hax only works on 3349. You will need an 8 pin adapter to jtag either chip. there is a 1 click batchfile method here somewhere....little scary though if it bricks and you do not have a jtag.

tutorial is here or at sbhacker.net.

(27-05-2013, 12:54 AM)southernyankey1970 Wrote: [ -> ]2100 OR 2100R2.

2100 has 3348 chip r2 has 3349 chip. Hax only works on 3349. You will need an 8 pin adapter to jtag either chip. there is a 1 click batchfile method here somewhere....little scary though if it bricks and you do not have a jtag.

tutorial is here or at sbhacker.net.

Thanks for the reply
EPC2100R2

(27-05-2013, 06:14 PM)psx Wrote: [ -> ]

(27-05-2013, 12:54 AM)southernyankey1970 Wrote: [ -> ]2100 OR 2100R2.

2100 has 3348 chip r2 has 3349 chip. Hax only works on 3349. You will need an 8 pin adapter to jtag either chip. there is a 1 click batchfile method here somewhere....little scary though if it bricks and you do not have a jtag.

tutorial is here or at sbhacker.net.

Thanks for the reply
EPC2100R2

I flashed it with one click but now all lights are on even when I take out the ethernet port.

LOL...

Bricked..

Sigh....

Warned ya! Hard introduction to modem flashing! Break out your wallet and buy a jtag and then flash it the correct way. there is a thread here on tools you will find very helpful.

Better yet get a better modem and at least a Blackcat usb. I highly suggest a 5101 as that is the easiest to flash and debrick. 2100's are cheap and they fail a lot....at least the ones i had did.