well the leased the points are there, me i'd solder in a header
if your not the greatest at soldering flip the board as its easier to solder from the back, flux the 4 points and add some more solder
cut the ends off your jumper cables and tin the ends, and solder them to the points
Ok thanks alot mate gunna give it ago
so the pins still in this order Rx Tx gnd 3v
GREAT !!!! im now into putty i see things loading , this is my log after uploading that image1.bin
Location: 0xbec10000
Unable to load selected image1 on location (A).
Trying to find images from other location...
BCM3349A0
1346890
SA BootLoader Version: 2.1.7l_R3(S) Release Gnu reduced DDR drive
Build Date: Oct 23 2008
Build Time: 16:48:52
Flash detected @0xbe000000
(A). Image 1 Program Header:
Location: 0xbec10000
Unable to load selected image1 on location (A).
Trying to find images from other location...
(A). Image 1 Program Header:
Location: 0xbec10000
Unable to load selected image1 on location (A).
Trying to find images from other location...
(A). Image 1 Program Header:
Location: 0xbec10000
Unable to load selected image1 on location (A).
Trying to find images from other location...
(A). Image 1 Program Header:
Location: 0xbec10000
what should i do to get me back online because i dont have the p option , the secound im in putty it loads all that msg
mine is different than that mate That Person ' Gets Abit More Than Me lol
eCos - hal_diag_init
Init device '/dev/ttydiag'
Init tty channel: 80338648
Init device '/dev/tty0'
Init tty channel: 80338668
Init device '/dev/haldiag'
HAL/diag SERIAL init
Init device '/dev/ser0'
BCM 33XX SERIAL init - dev: 0.2
Set output buffer - buf: 80369f68 len: 2048
Set input buffer - buf: 8036a768 len: 2048
BCM 33XX SERIAL config
Reading Permanent settings from non-vol...
Checksum for permanent settings: 0xf2590556
Settings were read and verified.
Reading Dynamic settings from non-vol...
Checksum
'
where mine was just
SA BootLoader Version: 2.1.7l_R3(S) Release Gnu reduced DDR drive
Build Date: Oct 23 2008
Build Time: 16:48:52
Flash detected @0xbe000000
(A). Image 1 Program Header:
Location: 0xbec10000
Unable to load selected image1 on location (A).
Trying to find images from other location...
Dont Wurry about the bootloader lol u only trying help me man
With The JTAG does it matter if i use a USB JTAG or The Pararel Port JTAG ? With The Jtag Utility ?
I Really Appreciate Your Help Drew
only usbjtags that work with toms are ftdi based usbjtags (and the only person i know with one of those is me)