Hi,
I loaded hax v39 using parallel jtag. No errors but when I reset modem I see no booting lights at all. I have heard that it might be the standby button might be the cause because hax disable standby button. Is there a way to work around this issue?
Thanks.
(22-08-2014, 11:30 PM)pendrag Wrote: [ -> ]Hi,
I loaded hax v39 using parallel jtag. No errors but when I reset modem I see no booting lights at all. I have heard that it might be the standby button might be the cause because hax disable standby button. Is there a way to work around this issue?
Thanks.
you installed hax over a stock 5101 that was working properly before you installed hax?
(22-08-2014, 11:34 PM)newname Wrote: [ -> ] (22-08-2014, 11:30 PM)pendrag Wrote: [ -> ]Hi,
I loaded hax v39 using parallel jtag. No errors but when I reset modem I see no booting lights at all. I have heard that it might be the standby button might be the cause because hax disable standby button. Is there a way to work around this issue?
Thanks.
you installed hax over a stock 5101 that was working properly before you installed hax?
Yes, it was working properly before loading hax. Booting lights were showing just fine. Thx.
(22-08-2014, 11:46 PM)sixteen Wrote: [ -> ]You killed it.
Just to learn from my mistake. What must I had done before loading hax on this model? I am assuming there is nothing I can do now, right?
(23-08-2014, 01:56 AM)dragonlord7791 Wrote: [ -> ]flash this on it whith verify and skyp error at 67 percent...
is a full flash hax
https://mega.co.nz/#!MZQy3ZrA!y-0EziWk7E...prE_wXxdLg
i was using whit black cats swarzerkaze,and alwais work,the modem will back to life
Gee, thx man, I will try it and let you know how it goes. Regards.
(23-08-2014, 01:56 AM)dragonlord7791 Wrote: [ -> ]flash this on it whith verify and skyp error at 67 percent...
is a full flash hax
https://mega.co.nz/#!MZQy3ZrA!y-0EziWk7E...prE_wXxdLg
i was using whit black cats swarzerkaze,and alwais work,the modem will back to life
apparently i did the same thing, do you by any chance have a similar file but with rev 39 on it?
Reflash with this.
THEN reflash hax 39
Revive the cm with the old, whored-out 5101 dump and then when it boots normally flash Hax. Follow the guides for this.
Doesnt he have to flash a boot file before he can flash a 2mb dump?