Haxorware Forums

Hang on a sec.....once drew finishes his tea and crumpets....he will give you a few more tips.....unless of course he has a cricket match to go to.

Is there any settings I would have to put windows 7 and FC classic

(06-10-2019, 01:20 PM)newname Wrote: [ -> ]Hang on a sec.....once drew finishes his tea and crumpets....he will give you a few more tips.....unless of course he has a cricket match to go to.

Sounds like the rapper 21 Savage

(24-03-2015, 07:05 AM)drewmerc Wrote: [ -> ]hit the reset button

Help me Out Drew I haven’t slept pleaseeee

hold the reset button and then plug it in, if that fails flip the switches and try again

I tried it an switched the switches every way and it still blinks do I need a tftp set up

what are you trying to do?

Just make my fc visible.. do I have to flash it with boot utility? I’m stuck

let me see if I understand @Andrew956 ...

Do you have your FCUSB with problems to recognize?
You can do the following:

° lower the switch in bootloader mode, there you have an example



° press the bootloader button with the fcusb obviously connected, no matter if the software is not open.
° open any version of the Flashcatusb software [compatible with the pcb version of fcusb classic]
° click AVR Firmware and Load File
° select fw FCUSB.CLASSIC.x.xx.PCBx.x.hex compatible with your version of Flascatusb classic.
° click Program
° after it is programmed, click on Start Application