23-11-2017, 10:57 AM
neo_ wrote:
It's also important, power on then modem normally with it's own power source. Then, you should only have 3 cables for UART - Ground, Rx, Tx. Find the right ones and you'll see something.
I Tried this on windows 10 and XP (virtual) on 2 modemboards , but all I get it this :
[attachment=1203]
drewmerc wrote:
the looper your talking about is just connecting tx and rx and typing into terminal should echo back (thus telling you it works).
I tested this , but Putty gives me the same screen .
Will the Chinese FT232H work with BlackCat/FlashCat or is there some kind of check in the software ?
It's also important, power on then modem normally with it's own power source. Then, you should only have 3 cables for UART - Ground, Rx, Tx. Find the right ones and you'll see something.
I Tried this on windows 10 and XP (virtual) on 2 modemboards , but all I get it this :
[attachment=1203]
drewmerc wrote:
the looper your talking about is just connecting tx and rx and typing into terminal should echo back (thus telling you it works).
I tested this , but Putty gives me the same screen .
Will the Chinese FT232H work with BlackCat/FlashCat or is there some kind of check in the software ?