Haxorware Forums

Hello, I have an Ambit/Ubee 256 and I have a slight problem (If in incorrect section, could you please move it?)

The guy that flashed it left all the timeouts and so tick.
I have untick and 'Save and Reboot' the modem, but when I click save and reboot, it's seems it's not actually saving it, the modem crashes and nothing happens.

I do the same thing but this time only 'Save' IF the modem don't crash, it saves the successfully, but, when I reload the settings page, they're all tick again.

I don't know any other way around this.
Could someone help me reflash or get it to function correctly?

It's almost as if the chip is in a read only state, nothing will save.
Thank you.
-Scriptr.

could be a bad flash or a fuck up of the write protect
can you change the mac? as honestly the timeouts are not important (back up nonvol before playing with mac)
also watch the telnet output while changing shit it'll tell you if it's written to the flash

I cannot change mac at all.
As soon as I change it, it reverts to how it was before.

I'll run telnet and post the results.
Thanks.

Right, I did a telnet.
This is all it gave me.


DefaultSnmpAgentClass::ShutdownPendingEvent for SB5102 CM Agent w/ BRCM Factory Support
SB5102 CM Agent w/ BRCM Factory Support sending deferred traps...
Done w/ deferred traps.
SB5102 CPE Agent w/ BRCM Factory Support disabling management.
SB5102 CPE Agent w/ BRCM Factory Support defering traps.
CmSnmpAgent waiting for packets, events, and traps to clear...
Logging event: Resetting the cable modem due to docsDevResetNow
CmSnmpAgent waiting for packets, events, and traps to clear...
Logging event: Modem Is Shutting Down and Rebooting...

(I cannot switch the telnet server to start on boot because it crashes the haxorware? (Doesn't save the settings, just says 'Waiting'))

get it reflashed

Still nothing, i think the chip is f***ed