+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: telnet command (/showthread.php?tid=1242)
telnet command - skyline629 - 28-12-2011
Need command line for SB5100Mod to enable factory mode.
RE: telnet command - drewmerc - 28-12-2011
can't you just use snmp, factory mode tool or ip full (shit answer but i just spent the last 40 fucking minutes looking for it but damn i cant find it)
RE: telnet command - nutz - 28-12-2011
Gain telnet access.
Type cd n/s press enter.
Type allow_config true press enter.
Then type write press enter.
cd /
reset
This should put you into factory mode on the sb5100. Once you're done injecting your certs follow the steps above again but this time instead type allow_config false to get out of factory mode. I have been successful at getting my 5100 back online. It's a tedious process.
RE: telnet command - skyline629 - 28-12-2011
(28-12-2011, 05:22 AM)nutz Wrote: Gain telnet access.
Type cd n/s press enter.
Type allow_config true press enter.
Then type write press enter.
cd /
reset
This should put you into factory mode on the sb5100. Once you're done injecting your certs follow the steps above again but this time instead type allow_config false to get out of factory mode. I have been successful at getting my 5100 back online. It's a tedious process.
Thanks NutZ, I'll give it a try.