Haxorware Forums
SB5100 cant access GUI - Printable Version

+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: SB5100 cant access GUI (/showthread.php?tid=3316)

Pages: 1 2 3


SB5100 cant access GUI - linxip1989 - 24-10-2014

I couldn't access to GUI (192.168.100.1 or 192.168.100.1:1337/666)" page not found " i try with sigma x n SB5100MoD firmware
I could get in to 192.168.100.1 if i flash it with firmware:
SB5100-2.3.9.0-GA-00-NOSH-NNDMN
I have try different boot loader as well but no luck
PLEASE HELP


RE: SB5100 cant access GUI - Box3r - 24-10-2014

try settings your dhcp settings to

192.168.100.10

255.255.255.0

192.168.100.1 Or Try Without This <-


RE: SB5100 cant access GUI - linxip1989 - 24-10-2014

(24-10-2014, 07:55 PM)Box3r Wrote: try settings your dhcp settings to

192.168.100.10

255.255.255.0

192.168.100.1 Or Try Without This <-

I just try that no luck. I have Win 7 do i just change
Internet Protocol version 4(TCP/IPv4) ?


RE: SB5100 cant access GUI - southernyankey1970 - 25-10-2014

CHANGE NIC ADDY, unplug coax,reset modem and nic


RE: SB5100 cant access GUI - linxip1989 - 25-10-2014

(25-10-2014, 03:40 AM)southernyankey1970 Wrote: CHANGE NIC ADDY, unplug coax,reset modem and nic

How Do i change network interface card "ADDY" . The coax was never plug in just power n ethernet cable


RE: SB5100 cant access GUI - ricktendo - 25-10-2014

Its the same with Haxorware, if you are not connected to the net then accessing the weg gui is sometimes impossible... If you restart the modem and catch it during the early stages of boot up you may get lucky


RE: SB5100 cant access GUI - linxip1989 - 25-10-2014

(25-10-2014, 08:30 AM)ricktendo Wrote: Its the same with Haxorware, if you are not connected to the net then accessing the weg gui is sometimes impossible... If you restart the modem and catch it during the early stages of boot up you may get lucky

so you mean i should try connecting the coax than try to access the GUI ?

There's some problem with this modem The power light is blinking The ethernet lights up normal but for the coax it does not light up even when is plug in


RE: SB5100 cant access GUI - ricktendo - 25-10-2014

Or, reboot the router and act fast


RE: SB5100 cant access GUI - Box3r - 25-10-2014

Yes Ipv4


RE: SB5100 cant access GUI - linxip1989 - 27-10-2014

(25-10-2014, 03:10 PM)Box3r Wrote: Yes Ipv4

i try that but it didnt work is there any other solution ?