+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: Telenet Command To Clear NAT (/showthread.php?tid=3656)
Telenet Command To Clear NAT - GreekDad - 02-07-2015
Anyone know of a Telenet command I can use to clear the NAT table?
RE: Telenet Command To Clear NAT - neo_ - 02-07-2015
DOCSIS does not have a NAT protocol.
RE: Telenet Command To Clear NAT - GreekDad - 02-07-2015
Haxorware has a NAT table inside of it that when it gets too full due to too many IP changes you must reboot the modem to clear this table. I want to clear this table without rebooting the modem.
RE: Telenet Command To Clear NAT - neo_ - 02-07-2015
(02-07-2015, 06:53 AM)GreekDad Wrote: Haxorware has a NAT table inside of it that when it gets too full due to too many IP changes you must reboot the modem to clear this table. I want to clear this table without rebooting the modem.
That is not a NAT table. It is called a routing table.
Stop using so many torrent seeds or get a modem with more memory.
RE: Telenet Command To Clear NAT - Canis-Major - 02-07-2015
Another downside to the so called new security, is that you cant change ip's as often as used to be possible, and I would go as far as to say, ip's are now like your postcode, your stuck with it, how else dya think they'll catch all those pirate's? You may be able to change last 4 digit's, but no more, this I can defo confirm is in effect here, same ip give or take a few digit's since 2010