Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
my sb5102e bricked with haxoware,help me please!
#1
Sad
i have a sb5102e ,normal online,when i flash haxoware 11 ver39,it bricked,all the lights are not bright,so i must restore 2mb dump, i flash it more than ten times,among them are a normal,but cant online,the fifth led flashing
i use usbjtagnt 0.54 program image0 and image1,with haxorware11rev39-DIAG.bin,but my doubt is haxorware11rev39-DIAG.bin is more than 1mb, how can program both image0 and image1,if the data are same in image0 and image1 ?
the cm's certs is correct, why cant online?the cfg file is base on docsis 1.1 , and why can i flash haxoware to make it bricked?
thank u for ur reply!

update: now i know the method was wrong,i load haxorware to image 0 and program image0 ,and then load it to image 1 and program image1 - -!
i program it again ,now it works well,but cant online ,the fifth led flashing always...
Reply
#2
why don't you just flash the lite version?
No I will not help you if only have a few worthless post on the forum.
Reply
#3
(29-12-2011, 08:24 PM)skribblz Wrote: why don't you just flash the lite version?

sb5102e have no ejtag,i program use spi,
lite version does not support SPI flash based modems
Reply
#4
you only program image0
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)