Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Is it possible to activate a Haxorware FW Modem by calling the ISP?
#1
Hi Guys, Is it possible to call up an ISP and have them activate the a brand new store bought modem with the Haxoreware Diagnostic menu already installed into it if the original modems stock information was unmodified? If yes does any know what settings to leave unchecked in order ensure that it gets successfully activated. Thank you guys for the help....
Reply
#2
Yeah just tell them what your MAC Address is then they will use that MAC Address to serve as what ever service you pay for.
[Image: 2067907098.png]
Reply
#3
Not on CC...

Most d3 isp's can see Hax during the handshake if they have enabled that on their CMTS firmware. Most D3 isp's also REQUIRE that your modem take the cosigned push from them before you are given access to their network so it would be pointless to provision a cm with Hax as they will overwrite it anyways.
Reply
#4
[quote='southernyankey1970' pid='14369' dateline='1349061497']
Not on CC...

Most d3 isp's can see Hax during the handshake if they have enabled that on their CMTS firmware. Most D3 isp's also REQUIRE that your modem take the cosigned push from them before you are given access to their network so it would be pointless to provision a cm with Hax as they will overwrite it anyways.
[/quote ]
Now would the cm have to be a d3? or would this also apply to 1.1 and 2.0
since many CC still use the older cm, many systems that I know of, do
not have 100% d3.
Reply
#5
the push applys to 1.1 and 2.0
__________________________________________________________________________________
******new discord chat linkĀ https://discord.gg/5BQQbsb*******
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)