Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cisco DTA 271HD
#1
I want to read the log on this device with a USB to TTL adapter. I'm hooked up as follows:

USB TTL SPI Winbond
Receive => Pin 2 (SO)
Transmit => Pin 5 (SI)
Ground => Pin 4 (GND)
Putty config:
Baud rate 115200
8 none 1
Flow control set to NONE

I'm just getting garbage though.
Can I even read this? I should, right? Just want to see how it boots up.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)