Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
NETGEAR CMD31T LED not working with forceware CMD31T
#1
i manged to flashed the CMD31T, and uploaded some cert. The cm went online and its working . but the only light on is the power. so i think while programing it i used the wrong xml of a 6120 . to write on the ubfi1 and 2 what are the memory locations?

ldram 0?????
and
ldram ubfi2 ??
Reply
#2
Same as 6120 ldram 0 7f0000 ubf2 and ldram 0 4000 ubf1
Reply
#3
(23-12-2016, 01:30 AM)eltremendo Wrote: i manged to flashed the CMD31T, and uploaded some cert. The cm went online and its working . but the only light on is the power. so i think while programing it i used the wrong xml of a 6120 . to write on the ubfi1 and 2 what are the memory locations?

ldram 0?????
and
ldram ubfi2 ??


Could you please tell me the configuration you used in forceware to put the CMD31T online
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)