Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Alpha 3.0 Questions
#1
Hi Guys,

I have a couple of questions regarding this firmware on sb6141.

1- Can I get online with alpha 3.0 using just macs? o this is just with alpha 1.0? ( I'm able to get it online with forceware with just mac)

2- What is the alpha log path? I'm troubleshooting it and it does not get online.. I want to see the log.

3 - is there any debug mode on the alpha 3.0, that I can run over ssh to see all the status information on verbose or debug mode?

4- Is there a post or document for alpha commands? or I just have to refer to the busybox doc?

At this point I should able to get it online with just mac and bpi-disabled.

It gets signal.. and it gets stucked on the internet light ( blinking ).



Thanks in advance.
Reply
#2
BPI-DISABLED? That was DOCSIS 1.0
Reply
#3
(10-06-2018, 10:09 PM)Geno_Smith Wrote: BPI-DISABLED? That was DOCSIS 1.0


Yes, I'm able to connect with docsis 1.0 and bpi-disable using force.. but not with alpha.

On alpha 3.0 I only change the mac and bpi-disable.. but it gets blinking on online led.. and there start ranging again.

I want to see the logs.. but I don't' know the path of them.

Thanks,
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)