Hello i need help flashin sb5101e i purchased flashcat usb but is not detecting what pins to solder for flashcat usb, i have soldered J201
and tell me pls step by step what i need to flash first bootloader or diag or lite firmware thanks
Guttentag,
You do not need to flash the bootloader. Just flash Diag.
Did you install drivers, is it detected in your device manager?
Your PIN 1 seems to be reversed, the red stripe on the cable always signifies PIN1.
Guttentag .. ops i tried 5 hours and the problem why not detected was .cuz first we must install firmware into flashcat after flashed firmware modem was detected..
Features of FCUSB.7.05.EJTAG_32K
but when i select write haxorware11rev39-DIAG i have error or just writing CFI Flash ?
i flashed
thanks