Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Flash SB5101E With FlashcatUSB help
#1
Hello i need help flashin sb5101e i purchased flashcat usb but is not detecting what pins to solder for flashcat usb, i have soldered J201

and tell me pls step by step what i need to flash first bootloader or diag or lite firmware thanks

[Image: ag6lwkw4.jpg]


[Image: WbLvJpg.jpg]
[Image: 3811042289.png]
Reply
#2
Guttentag,

You do not need to flash the bootloader. Just flash Diag.

Did you install drivers, is it detected in your device manager?

Your PIN 1 seems to be reversed, the red stripe on the cable always signifies PIN1.

[Image: sb5101.jpg]
Reply
#3
Guttentag .. ops i tried 5 hours and the problem why not detected was .cuz first we must install firmware into flashcat after flashed firmware modem was detected..
Features of FCUSB.7.05.EJTAG_32K

but when i select write haxorware11rev39-DIAG i have error or just writing CFI Flash ?

i flashed Smile thanks


Attached Files Thumbnail(s)
       
[Image: 3811042289.png]
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)