+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: getting to config page (/showthread.php?tid=2900)
Pages:
1
2
RE: getting to config page - teddyalmonds - 08-01-2014
Transmit power is 8.3 dBmV and receive power is 25.6.
I've only experienced this if
1) The tuner on the modem is physically damaged.
2) I'm not getting a signal from the outside line (for example - maybe the line is not connected or there is a filter on the tap)
RE: getting to config page - Sokalm - 08-01-2014
i think the modem is shot... it connect to the config page, but it doesn't do nothing b ut scan, and says not sync. I tried multiple places, my sister house and my friend. I went ahead and put it on the shelf as a back up, and i am going to load up Sigma X2 on another modem and see if that work better for me. Thank you for thelp.
RE: getting to config page - teddyalmonds - 08-01-2014
Sorry to hear that man. As soon as I saw 8.3 dBmV I knew the modem probably had something wrong with it. It's what happened to me on a few occasions when repairing modems.
RE: getting to config page - Sokalm - 09-01-2014
(08-01-2014, 10:46 PM)teddyalmonds Wrote: Sorry to hear that man. As soon as I saw 8.3 dBmV I knew the modem probably had something wrong with it. It's what happened to me on a few occasions when repairing modems.
let's just hope this one goes better. i'll keep y'all updated.
RE: getting to config page - teddyalmonds - 09-01-2014
Good luck man.