Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help, SB5120 bad need certs to clone to my Haxorware modem
#8
ok I tried doing this like I would do on a sb5101. I soldered the pin header for my JTAG Cable and it only went on the pins I circled in the pic below. I then loaded JTAG Utility and opened the LPT Cable then told it to detect. When I do that It says:
"Read IDCODE: 0x0000100f
Manufacturer: Hitachi
Part: 0x0001
Version: 0x0
---------------------------------"

I cant get it to detect. Is there something else I was supposed to do?

[Image: cawrk.jpg]
Reply


Messages In This Thread
RE: Help, SB5120 bad need certs to clone to my Haxorware modem - by CableGuRu - 07-07-2012, 05:09 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)