14-10-2012, 03:55 PM
here is my telnet log iff this helps
=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2012.10.14 15:47:15 =~=~=~=~=~=~=~=~=~=~=~=
Haxorware integrated telnet daemon
Username: SHOCK
Password: ******
Welcome.
CM>
CM> run
CM>
CM> run_app
Running the system...
Beginning Cable Modem operation...
0x0000ee2a [Scan Downstream Thread] BcmVendorCmDownstreamScanThread::ThreadMain: (Scan Downstream Thread) Scanning for a Downstream Channel...
mot_scanList: Setting override freq @ 0
Favorite[0].freq = 331000000
Attempting Downstream FEC lock @ freq= 331000000 Hz, QAM64/256
CM> Found energy at frequency 331000000Hz! Publishing event kEventEnergyDetected...
0x0000f226 [CmDocsisCtlThread] BcmCmDocsisCtlThread::StartUsInit: (CmDocsisCtlThread) Locked on the downstream. Waiting for UCDs...
******************************************
DOWNSTREAM STATUS
******************************************
Tuner Frequency = 331000000 Hz
Carrier Offset = -13 Hz
Symbol rate = 5360537 sym/sec
SNR = 36 dB
QAM Mode = QAM256
Tuner AGC = 0xfff00000
IF AGC = 0x14f0e0a3
Power Level = 1 dB
QAM = LOCKED
FEC = LOCKED
******************************************
CM> Selecting UCD for Us Channel 2
0x0000fd16 [CmDocsisCtlThread] BcmCmDocsisCtlThread::TestAndLaunchDsTimeSync: (CmDocsisCtlThread) starting ds time sync acquisition...
0x0000ff96 [CmDocsisCtlThread] BcmCmDocsisCtlThread::SyncDsSyncOk: (CmDocsisCtlThread) downstream time sync acquired...
0x0000ff96 [CmDocsisCtlThread] BcmCmDocsisCtlThread:sSyncOkResumeUsInit: (CmDocsisCtlThread) pre-REG upstream target case...starting initial ranging.
Beginning initial ranging...
Using stored initial upstream power = 8.0 dBmV
0x0000ffa0 [CmDocsisCtlThread] BcmCmDocsisCtlThread::SyncDsSyncOk: (CmDocsisCtlThread) rx unexpected kDsSyncOk indication...
Not logging event ID 2307948724, control for level 7 is 0.
CM> Adjusting the initial ranging power to 33.0 dBmV...
Logging event: No Ranging Response received - T3 time-out (US 2)
CM> Adjusting the initial ranging power to 46.0 dBmV...
Logging event: No Ranging Response received - T3 time-out (US 2)
CM>
RNG-RSP Adj: tim=2449 power=10 freq=0 Stat=Continue
CM>
RNG-RSP Adj: tim=0 power=0 freq=0 Stat=Success
******************************************
UPSTREAM STATUS
******************************************
Upstream Status = UP
Upstream Channel = 2
Upstream Frequency = 22200000 Hz
Upstream Power = 48 dBmV
Ranging SID = 0x1fe6
Upstream Symbol Rate = 1280000 sym/sec
******************************************
Calculating maximum number of IP filters:
Each IP filter consumes 1852 bytes of RAM.
Current free RAM is 497756 bytes.
Max heap reserved for IP filters (25%) = 124439
We can support 67 IP filters.
Calculating maximum number of LLC filters:
Each LLC filter consumes 712 bytes of RAM.
Current free RAM is 497736 bytes.
Max heap reserved for LLC filters (25%) = 124434
We can support 174 LLC filters.
Starting IP Initialization with DHCP...
DHCPc: Waiting 1 seconds before sending Discover; client id htype=1, value=00:20:40:XX:XX:XX
Not logging event ID 2307948624, control for level 7 is 0.
CM> DHCPc: Sending Discover packet; client id htype=1, value=00:20:40:XX:XX:XX
CM> DHCPc: Timed out waiting for offers for lease with client id htype=1, value=00:20:40:XX:XX:XX
DHCPc: No valid offers to select; need to send discover again.
Logging event: DHCP FAILED - Discover sent, no offer received
CM> DHCPc: Sending Discover packet; client id htype=1, value=00:20:40:XX:XX:XX
CM> DHCPc: Timed out waiting for offers for lease with client id htype=1, value=00:20:40:XX:XX:XX
DHCPc: No valid offers to select; need to send discover again.
Logging event: DHCP FAILED - Discover sent, no offer received
CM> DHCPc: Sending Discover packet; client id htype=1, value=00:20:40:XX:XX:XX
CM>
=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2012.10.14 15:47:15 =~=~=~=~=~=~=~=~=~=~=~=
Haxorware integrated telnet daemon
Username: SHOCK
Password: ******
Welcome.
CM>
CM> run
CM>
CM> run_app
Running the system...
Beginning Cable Modem operation...
0x0000ee2a [Scan Downstream Thread] BcmVendorCmDownstreamScanThread::ThreadMain: (Scan Downstream Thread) Scanning for a Downstream Channel...
mot_scanList: Setting override freq @ 0
Favorite[0].freq = 331000000
Attempting Downstream FEC lock @ freq= 331000000 Hz, QAM64/256
CM> Found energy at frequency 331000000Hz! Publishing event kEventEnergyDetected...
0x0000f226 [CmDocsisCtlThread] BcmCmDocsisCtlThread::StartUsInit: (CmDocsisCtlThread) Locked on the downstream. Waiting for UCDs...
******************************************
DOWNSTREAM STATUS
******************************************
Tuner Frequency = 331000000 Hz
Carrier Offset = -13 Hz
Symbol rate = 5360537 sym/sec
SNR = 36 dB
QAM Mode = QAM256
Tuner AGC = 0xfff00000
IF AGC = 0x14f0e0a3
Power Level = 1 dB
QAM = LOCKED
FEC = LOCKED
******************************************
CM> Selecting UCD for Us Channel 2
0x0000fd16 [CmDocsisCtlThread] BcmCmDocsisCtlThread::TestAndLaunchDsTimeSync: (CmDocsisCtlThread) starting ds time sync acquisition...
0x0000ff96 [CmDocsisCtlThread] BcmCmDocsisCtlThread::SyncDsSyncOk: (CmDocsisCtlThread) downstream time sync acquired...
0x0000ff96 [CmDocsisCtlThread] BcmCmDocsisCtlThread:sSyncOkResumeUsInit: (CmDocsisCtlThread) pre-REG upstream target case...starting initial ranging.
Beginning initial ranging...
Using stored initial upstream power = 8.0 dBmV
0x0000ffa0 [CmDocsisCtlThread] BcmCmDocsisCtlThread::SyncDsSyncOk: (CmDocsisCtlThread) rx unexpected kDsSyncOk indication...
Not logging event ID 2307948724, control for level 7 is 0.
CM> Adjusting the initial ranging power to 33.0 dBmV...
Logging event: No Ranging Response received - T3 time-out (US 2)
CM> Adjusting the initial ranging power to 46.0 dBmV...
Logging event: No Ranging Response received - T3 time-out (US 2)
CM>
RNG-RSP Adj: tim=2449 power=10 freq=0 Stat=Continue
CM>
RNG-RSP Adj: tim=0 power=0 freq=0 Stat=Success
******************************************
UPSTREAM STATUS
******************************************
Upstream Status = UP
Upstream Channel = 2
Upstream Frequency = 22200000 Hz
Upstream Power = 48 dBmV
Ranging SID = 0x1fe6
Upstream Symbol Rate = 1280000 sym/sec
******************************************
Calculating maximum number of IP filters:
Each IP filter consumes 1852 bytes of RAM.
Current free RAM is 497756 bytes.
Max heap reserved for IP filters (25%) = 124439
We can support 67 IP filters.
Calculating maximum number of LLC filters:
Each LLC filter consumes 712 bytes of RAM.
Current free RAM is 497736 bytes.
Max heap reserved for LLC filters (25%) = 124434
We can support 174 LLC filters.
Starting IP Initialization with DHCP...
DHCPc: Waiting 1 seconds before sending Discover; client id htype=1, value=00:20:40:XX:XX:XX
Not logging event ID 2307948624, control for level 7 is 0.
CM> DHCPc: Sending Discover packet; client id htype=1, value=00:20:40:XX:XX:XX
CM> DHCPc: Timed out waiting for offers for lease with client id htype=1, value=00:20:40:XX:XX:XX
DHCPc: No valid offers to select; need to send discover again.
Logging event: DHCP FAILED - Discover sent, no offer received
CM> DHCPc: Sending Discover packet; client id htype=1, value=00:20:40:XX:XX:XX
CM> DHCPc: Timed out waiting for offers for lease with client id htype=1, value=00:20:40:XX:XX:XX
DHCPc: No valid offers to select; need to send discover again.
Logging event: DHCP FAILED - Discover sent, no offer received
CM> DHCPc: Sending Discover packet; client id htype=1, value=00:20:40:XX:XX:XX
CM>
Always be yourself, express yourself, have faith in yourself!!!
Regardless of who starts first; ability decides seniority !!!!!
Regardless of who starts first; ability decides seniority !!!!!