06-06-2015, 12:24 PM
(This post was last modified: 06-06-2015, 12:40 PM by Canis-Major.)
What easier way to enable cpe snmp control than setting tlv_55 to true? This is NOT the factory mode that can also allow CERTAIN snmp access..
It's rather funny the idiot's here that cant read what is in the modem's help, as in cpe CONTROL of snmp.
I found that I can snmp anywhere through my 480, in router mode, and use sniffer's etc with tlv_55 enabled, when off, i get what appear's to be no snmp, and I knw it will be the same everywhere else, troll on that loser's.. get a grip and try to be fuckin constructive, instead of negative receptive pussies. Think you can help? Dont even try to, start fuckin doing!
I'll also add that NMaccess view is a handy function too..
To enable snmp on docsis 3, it's best to edit the dump in hex, then flash.
It's amazing how clean the forum get's when ye scrape the shit of yer screen with them new ignore wipe's..
It's rather funny the idiot's here that cant read what is in the modem's help, as in cpe CONTROL of snmp.
I found that I can snmp anywhere through my 480, in router mode, and use sniffer's etc with tlv_55 enabled, when off, i get what appear's to be no snmp, and I knw it will be the same everywhere else, troll on that loser's.. get a grip and try to be fuckin constructive, instead of negative receptive pussies. Think you can help? Dont even try to, start fuckin doing!
I'll also add that NMaccess view is a handy function too..
To enable snmp on docsis 3, it's best to edit the dump in hex, then flash.
It's amazing how clean the forum get's when ye scrape the shit of yer screen with them new ignore wipe's..