07-08-2015, 06:12 AM
(This post was last modified: 07-08-2015, 06:22 AM by Canis-Major.)
In my mind, it's 2 x 128. You are aware, despite your post, that folks get different reading's, for instance, The first anyone found out is it's a 256 chip, only to be told the above, making it 128, but if it shows as 256..? It must have 256 capabilities, even if it is only using 2 x 8mb banks.. so here we have a dual flash, which shows as 128mb, but also claim's to have a third., meaning there is more than 128mb space in order to move the files around..
Note this (quoting you) : The default condition at power-up and after reset, is the Bank address register loaded with zeros and the extended address mode set for 24-bit addresses. This enables legacy software compatible access to the first 128 Mbits of a device. Voila. MORE than 128. Since even here it declares access to the 1st 128mb, not the other..
Ps, I read usbjtag, re: this, wow, was in stitches..
1 - 0 to virgin.
And yes andy, I got 3 x 490's, working on one
And if/when it's done, keep in mind gateway setting's wont work across modems, as in, you cant use gateway settings from one 490 and use it in another, I have tested this with 5 box's.. chances are the gateway setting's now check for private root cert, if it dont match what's in the gateway setting's, it wont work, however, most likely, each modem creates a different crc for the setting's, meaning one wont work in the other, for reasons I mentioned in other thread's, that like the bpi.bin not loading, wrong crc, unless it matches, it wont load.
Note this (quoting you) : The default condition at power-up and after reset, is the Bank address register loaded with zeros and the extended address mode set for 24-bit addresses. This enables legacy software compatible access to the first 128 Mbits of a device. Voila. MORE than 128. Since even here it declares access to the 1st 128mb, not the other..
Ps, I read usbjtag, re: this, wow, was in stitches..
1 - 0 to virgin.
And yes andy, I got 3 x 490's, working on one
And if/when it's done, keep in mind gateway setting's wont work across modems, as in, you cant use gateway settings from one 490 and use it in another, I have tested this with 5 box's.. chances are the gateway setting's now check for private root cert, if it dont match what's in the gateway setting's, it wont work, however, most likely, each modem creates a different crc for the setting's, meaning one wont work in the other, for reasons I mentioned in other thread's, that like the bpi.bin not loading, wrong crc, unless it matches, it wont load.