Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SB5101 with Ethernet problem after installing haxoware
#4
(27-05-2017, 07:44 PM)sforzando Wrote: Cloning one of your PC's mac to match your router's might be worth trying.

Actually i did that without results, BUT, it gave me an idea, i set up the ethernet card to 10baset half duplex instead of auto negotiation, and bum!, the link is ok, its weird but now i know for sure that is related to the ethernet port directly, now i need to find how to fix it.

(26-05-2017, 08:24 PM)occalifornia Wrote: - The ethernet port could be bad
- The modem hardware could be failing
- You could have damaged the modem when opening and flashing it
- The flashed firmware could have been corrupted

after a sugestion made before from "sforzando", i found out that maybe is the port itself, it only works at 10baseT, is not even working with 100mb ethernet, so i was wondering if the firmware have control over the port, and how can i change it?, or in any case, if the hardware is the problem, what would you suggest that i should try?
Reply


Messages In This Thread
RE: SB5101 with Ethernet problem after installing haxoware - by adm2008 - 29-05-2017, 12:20 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)