Thread Rating:
  • 2 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ssh command to switch boot partitions?
#1
Is there such a command in Alpha 3.0? In short am running Forceware on UBFI1, flashed Alpha 3.0 to UBFI2 and set it to boot to UBFI2 in Forceware. Not thinking about the fact that Alpha has no gui.

Hench my problem. Is there a way to set UBFI1 as boot partition from within Alpha 3.0 or am I goosed and need to reflash again with jtagnt. Thanks.

Edit. Modem is SB6121.
Reply
#2
(20-02-2017, 06:02 PM)coldfusion Wrote: Is there such a command in Alpha 3.0? In short am running Forceware on UBFI1, flashed Alpha 3.0 to UBFI2 and set it to boot to UBFI2 in Forceware. Not thinking about the fact that Alpha has no gui.

Hench my problem. Is there a way to set UBFI1 as boot partition from within Alpha 3.0 or am I goosed and need to reflash again with jtagnt. Thanks.

Edit. Modem is SB6121.

setenv ACTIMAGE 1
Reply
#3
You know your console bro. Thanks a lot. I'll try this in an hour or so. Is there a list for commands that are available for Alpha 3 anywhere? Appreciate it bro. Cheers.
Reply
#4
Worked great. Now to add the tools. Thanks bud!
Reply
#5
I did something similar, put alpha3 is in ub1 and force on ub2.
It booted on alpha, everything ok, so I switched to force. Set things up and went back to alpha again.
All good, but now, I cannot go back to force.

I do 'setenv ACTIMAGE 2' but it reboots in alpha again

any other way?
Reply
#6
Uart serial port
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)