Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
DCM 425?
#1
please post info/pics/pinout how you flash this modem-thanks!great site btw!
Reply
#2
same as the webstars
with serial cable
pinout is the same as the webstars: RX TX GND VCC from top to bottom (where top is the coax input)
[Image: 2qu0z8h.gif]
Reply
#3
Ok I built cable-I get to console- 1,2, p but it does not respond....
any way to fix this?or flash responsive firmware via snmp?please help thanks



(29-10-2008, 10:22 AM)rajkosto Wrote: same as the webstars
with serial cable
pinout is the same as the webstars: RX TX GND VCC from top to bottom (where top is the coax input)
Reply
#4
nope thats the only way check your TX line...but if its fine and modem still doesnt respond you are screwed you need to jtag it, but since it doesnt have any jtag points...
[Image: 2qu0z8h.gif]
Reply
#5
What about force firmware via SNMP?to a firmware that allows input?





(02-11-2008, 05:43 PM)rajkosto Wrote: nope thats the only way check your TX line...but if its fine and modem still doesnt respond you are screwed you need to jtag it, but since it doesnt have any jtag points...
Reply
#6
only signed
[Image: 2qu0z8h.gif]
Reply
#7
Nice Forum... Big Grin

Solutions for the RCA 425 ? With the console locked .....
I have 3 of theses...


Thanks
Reply
#8
lift the tsop flash a noisy bootloader + good firmware on

only way if p option doesnt work and firmware doesnt output anything
[Image: 2qu0z8h.gif]
Reply
#9
Any info on swapping the flash into a wrt54g/other mdm to flash? my flash chip broke-anyway I can replace it?Can I take flash chip from some other electronic device?or buy flash(s)?
Reply
#10
yes, but stop asking to be spoonfed, use google etc
[Image: 2qu0z8h.gif]
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)