Thread Rating:
  • 2 Vote(s) - 1.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tutorial to flash SPI chips with Parallel(LPT1) port
#6
Come to think of it, I do already have a USB SPI programmer, very similar (same chips) as this one:
http://www.ebay.com/itm/AVR-USB-JTAG-emu...1068485925

It is installed and in device manager it is a
Prolific USB to Serial Comm Port

I installed the avrstudio from Atmel, but it says it's not able to find the board, (I have no flash chip connected to flash at this time).

So what should I do? This parallel flashing post is really great, but I haven't found anything like that to go by with the USB Jtag SPI flasher I have on hand.
Reply


Messages In This Thread
RE: Tutorial to flash SPI chips with Parallel(LPT1) port - by Bruiser - 11-02-2015, 07:35 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)