Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wha is this?
#1
Hi, I'm pretty sure the MAC I'm using id from another node, but still the modem goes to an automatic reboot loop.

This what I get on the vent log:

2010-05-14 00:05:32 Critical I001.0 REG-RSP - invalid format or not recognized
1970-01-01 00:00:16 Critical D003.0 DHCP WARNING - Non-critical field invalid in response.
1970-01-01 00:00:05 Notice M571.1 Ethernet link up - ready to pass packets
2010-05-14 00:05:06 Notice M573.0 Modem Is Shutting Down and Rebooting...
2010-05-14 00:05:05 Critical R004.0 Received Response to Broadcast Maintenance Request, But no Unicast Maintenance o
2010-05-14 00:04:24 Critical I001.0 REG-RSP - invalid format or not recognized
1970-01-01 00:00:14 Critical D003.0 DHCP WARNING - Non-critical field invalid in response.
2010-05-14 00:02:53 Critical I001.0 REG-RSP - invalid format or not recognized
1970-01-01 00:00:16 Critical D003.0 DHCP WARNING - Non-critical field invalid in response.
1970-01-01 00:00:05 Notice M571.1 Ethernet link up - ready to pass packets
2010-05-14 00:02:25 Notice M573.0 Modem Is Shutting Down and Rebooting...
2010-05-14 00:02:25 Critical R004.0 Received Response to Broadcast Maintenance Request, But no Unicast Maintenance o
2010-05-14 00:01:31 Critical I001.0 REG-RSP - invalid format or not recognized
1970-01-01 00:00:18 Critical D003.0 DHCP WARNING - Non-critical field invalid in response.
1970-01-01 00:00:06 Notice M571.1 Ethernet link up - ready to pass packets
2010-05-14 00:01:03 Notice M573.0 Modem Is Shutting Down and Rebooting...


Any help is appreciated.

Thanks.
Reply
#2
is the mac from the same series modem that you're using?
You should look at the config it's pulling and spoof the proper strings, that's likely the problem.
Reply
#3
No, I'm using a SB5101 with haxorware and the MAC is from an Ambit.
Reply
#4
you need to spoof the proper strings for the ambit on your 5101.
Reply
#5
Can you show me exactly what I need to do? Please.
Reply
#6
http://mydeviceinfo.comcast.net/DisplayCMDevice.php

Shows you the current firmware version for devices, use this info to spoof via stealth tab.

You'll place the value you find from that url into the SOFTWARE VERSION section and model = model you're spoofing.
Reply
#7
Thanks I'll do that, and post back the results.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)