Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
need help xtract cert from 2mb
#11
i was not using any cable i was just using the software to manipulate the firmware
so yes you can do it with a parallel blackcat jtag cable (the commands are the same in toms jtag utility)
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
Reply
#12
I've 2MB flash dump from DCM305 and I've tried this methode to extract the nonvol after that I used cmnonexp to extract cert but cmnonexp cannot find any cert. The DCM305 has BCP 3345 like SB4200.
Reply
#13
seeing as the dcm305 is only d1 or d1.1 and not d2 like the sb510x i'll guess the memory location and the crc will be wrong
you could just try uploading the complete nonvol if it's the right size (i doubt it perhaps trying doubling it)
or you could try some local snmp to extract the certs

no idea if any of the above would work just throwing out ideas
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
Reply
#14
Heart 
How do i extract novol from 2mb flash of haxorware?????????
Undecided
Reply
#15
from within haxorware? use backup/restore part of haxor's webpage
if you mean from a 2mb dump read this thread
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
Reply
#16
(07-04-2012, 01:05 PM)drewmerc Wrote: from within haxorware? use backup/restore part of haxor's webpage
if you mean from a 2mb dump read this thread

how to download a full flash dump with shell commands? (not from within haxorware)
Reply
#17
1 thread leads to another question thread jaja
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)