I know this forum is only for Haxorware but somebody know how to use PJTAG to flash SB6120?

Not gonna work...

(02-13-2012 02:40 AM)ncb Wrote:  I know this forum is only for Haxorware but somebody know how to use PJTAG to flash SB6120?

you need usbjtagnt to flash sb6120 with forceware it work

(01-18-2009 10:43 PM)racky29 Wrote:  Rajko, im a bit concerned some people might follow your webstar layout on post 1 which is incorrect on the numbering
so ive modded it to the correct numbering, this should stop a lot of people moaning thier blackcat cant connect

Unbuffered Jtag Schematics for Surfboards and WebSTARs

note : pins 2 and 7 both need to be connected to GND
pin 8 is not used, and resistors are optional

=============================================
Surfboard to WebSTAR Converter Connections


--------------------------------------------------------------------
Surfboard to WebSTAR Converter Connections


--------------------------------------------------------------------
Pins 2 & 7 may need connecting to Gnd for best results, pin 8 is not used.

--------------------------------------------------------------------

Would the webstar layout work for the Netgear modem as well. I am trying to program my netgear cable modem with an unbuffered jtag cable

Can I connect motorola sb5101e directly to lpt-port (as it is drawn on the picture) to jtag it (for further flashing)?

I`ve opened my sb5101 (motorola) and there are no pins (2*5) as it is drawn. There are 2 groups of holes instead. In front of rj45 socket 4+6 (groups "J304" & "J303" in two rows, and lower (in front of usb-socket) 2*5 (group "J201"). Which one of them should I connect wires from the scheme to?

What is the difference between buffered and simple scheme of connection (if I can use simple, it is much easier for me)?