Hi guys im a noob need advice and bit explanations...
I have 2 modems EPC2100R2 (haxorware r39) and DPC2100R3 (stock). For about 2 years i was running on modded nicely until 3 days ago it stops and says auth reject on the logs with TLV-11 bad OID things. So now im running with my stock version which is slow as hell.
I tried to change bpi + docsis 1.1 and signal is locked but stuck on ranging complete wherenever it says sending registration it shows auth reject permanent blabla... so i think this happened because i dont have valid certs. i did try to copy my stock mac to hax but the error remains the same... the questions is if it possible to use the stock mac to hax and untick firmware upgrade as well enable SNMP after registration?? i want to trick CM to send valid certs, does this exposing my installed hax to cc?
I have 2 modems EPC2100R2 (haxorware r39) and DPC2100R3 (stock). For about 2 years i was running on modded nicely until 3 days ago it stops and says auth reject on the logs with TLV-11 bad OID things. So now im running with my stock version which is slow as hell.
I tried to change bpi + docsis 1.1 and signal is locked but stuck on ranging complete wherenever it says sending registration it shows auth reject permanent blabla... so i think this happened because i dont have valid certs. i did try to copy my stock mac to hax but the error remains the same... the questions is if it possible to use the stock mac to hax and untick firmware upgrade as well enable SNMP after registration?? i want to trick CM to send valid certs, does this exposing my installed hax to cc?