Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SB5100 and the 192.168.100.1 Page
#1
Hi,

I had done a factory reset (accident) on the mainpage and now I can't get to 192.168.100.1 page or by telnet. I tried applying a static IP to interface but it didn't work. Can some please tell me how to fix that? I only have a Parallel JTAG cable.

Thanks,
Reply
#2
What IP is being given?
Knowledge=Power
Reply
#3
reflash it
Reply
#4
(16-04-2012, 03:05 AM)southernyankey1970 Wrote: reflash it

I did that but it still doesn't work.
Reply
#5
Your in a BPI + network ...

All I will say is, this can be fixed..But its up to you
Knowledge=Power
Reply
#6
(16-04-2012, 02:17 AM)ABMJR Wrote: What IP is being given?

169.X.X.X
Reply
#7
Unplug the coax and then tell me what IP is given...You will get one. Your in new security and no DHCP server was found @ the CMTS
Knowledge=Power
Reply
#8
(16-04-2012, 04:16 AM)ABMJR Wrote: Unplug the coax and then tell me what IP is given...You will get one. Your in new security and no DHCP server was found @ the CMTS

That's the thing I'm talking about, I don't have the coax connected and this is happening. This is not the same CM as the other posts I was writing about earlier.
Reply
#9
reflash it with the original 2mb dump?
Reply
#10
(16-04-2012, 09:21 PM)torro32 Wrote: reflash it with the original 2mb dump?

Ah!, O.k. I'll try that.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)