Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Sb5101 Hax 1.1 rev 39 stuck on "registration complete"
drewmerc Offline
Prefect
******

Posts: 3,901
Threads: 19
Joined: Oct 2008
Reputation: 158
#11
RE: Sb5101 Hax 1.1 rev 39 stuck on "registration complete"
why 3 times? i only think 2
1st on a sub 2nd on hax
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
12-12-2011, 10:11 PM
Website Find Reply
qw1478 Offline
Junior Member
**

Posts: 9
Threads: 2
Joined: Dec 2011
Reputation: 0
#12
RE: Sb5101 Hax 1.1 rev 39 stuck on "registration complete"
Let's say, 1 from sub and 2 on 2 hax modems. Also whatever speed the cert/mac offers will be the speed of the hax given that cert correct?
12-12-2011, 10:29 PM
Find Reply
drewmerc Offline
Prefect
******

Posts: 3,901
Threads: 19
Joined: Oct 2008
Reputation: 158
#13
RE: Sb5101 Hax 1.1 rev 39 stuck on "registration complete"
i would not clone certs to 2 hax modems at the same time but thats me
yes your correct about speed/certs (just get certs from a fast modem)
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
12-12-2011, 11:08 PM
Website Find Reply
qw1478 Offline
Junior Member
**

Posts: 9
Threads: 2
Joined: Dec 2011
Reputation: 0
#14
RE: Sb5101 Hax 1.1 rev 39 stuck on "registration complete"
lol that is a problem, how am I going to find a fast modem. My sub modem is pretty slow, everyone I know has the same speed plus they probably would not let me use their certs
12-12-2011, 11:24 PM
Find Reply
drewmerc Offline
Prefect
******

Posts: 3,901
Threads: 19
Joined: Oct 2008
Reputation: 158
#15
RE: Sb5101 Hax 1.1 rev 39 stuck on "registration complete"
that's the tricky bit were people get stuck
__________________________________________________________________________________
******new discord chat link https://discord.gg/5BQQbsb*******
12-12-2011, 11:51 PM
Website Find Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)