Thread Rating:
  • 2 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SB5101 Firmware
#11
(10-09-2013, 07:55 PM)ABMJR Wrote: Call for a service call and make sure the rf plant is clean

whats the rf plant?
Reply
#12
call your service provider. Your coming across as semi-retarded
Knowledge=Power
Reply
#13
(10-09-2013, 09:36 PM)ABMJR Wrote: call your service provider. Your coming across as semi-retarded

Well thank you for being an ass. Now I know to not use this crappy site for anything because it's good for nothing.
Reply
#14
http://bit.ly/17WKS6I
Knowledge=Power
Reply
#15
lol...wow
Reply
#16
This is amazing
Reply
#17
lmao...

Amazing, he says...

Yawn!
Reply
#18
hello how are you and i will tell you any body that wants a sb 5101 to work you will need to jtag it serial port from computer to sb5101 board
Reply
#19
(24-03-2015, 03:07 AM)premiereTv Wrote: hello how are you and i will tell you any body that wants a sb 5101 to work you will need to jtag it serial port from computer to sb5101 board

EJTAG is better but serial port can do some little job.
Only JTAG can flash bootloader.

Region in flash Image1 or image2 you can dload from TFTP ip-addr name.bin
Then do command copy_image 2 1 - to copy from img2 to img1.
I did that do. (SB5101-2.11.0.0-GA-04-597-NOSH from this thread)
After this modem works fine, but I cant connect from terminal to serial port as it was before =( so JTAG is needed.
Reply
#20
well bummer.. I am not with TWC and i want to force the firmware also.. pLEASE Advise.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)